Aluminium Boat Pod Design

I would like to add a outboard pod with platform to give me more room in the boat. i would be building it out of marine ply and and fibreglass. i am unsure what measurments need to be taken in to consideration when building a pod.. Design by divtag weebly templates aluminum floatation pods - small aluminum floatation pods - small sku: $270.00. $270.00. these pods are ideally designed to be welded onto the boat. the drain plug in the pod should be taken out during welding to prevent welds from blowing out.. I have an aluminium boat, a stacer seahawk 4.2 that is bumdown and copping wash, it is due to the cmc trim tilt i installed added 50kgs to the back end and need some floatation pods like you have done running a 40 yammy enduro..

Abaco 23. [ab23] a classic looking sport fishing boat

Aluminum welding

Strand craft introduces new 122m superyacht thunderbird

The pod is fitted to the boat by cutting out a hole in the transom and glassing the pod in place and then the piece that was cut out is trimmed up and fitted back in the transom to close off the hole.. Re: outboard pod/bracket design this is a modification that i looked in to for my cabin boat as well. i decided against it because of the scale of the changes i would have to make are outside my capabilities on my boat.. Boat repairs and accessories. norweld are experts when it comes to repairs, alterations and modifications to boats. from a basic repair on a leaky hull up to a full aluminium canopy for the boat there is not much we have not done since 1971..

Related Posts by Categories